Where is ntbtlog.txt windows 7

Step 1: Fire up msconfig To open the tool, do the following: Click the Super-r aka Windows-R key combination to open the run dialog. Type msconfig. Click either OK or the Enter key to run the command. You'll receive a prompt to reboot the machine, which you'll need to do to complete the setup.

Figure A. Editor's Picks. Linux kernel 5. Windows Do these 11 things immediately. Top 5 things to do about your tech before you die. SYS Note that not every "Did Not Load Driver" message necessarily indicates an error that would prevent Windows from booting, because many drivers are not required for Windows to start. To repair problems caused by problematic drivers when you can start safe mode, follow these steps: Restart the computer and enable boot logging.

Restart the computer after it fails and then start safe mode. The boot log file opens in Notepad. Compare the list of drivers loaded in normal mode to the list of drivers loaded in safe mode. The driver that is causing the system to fail is one of the drivers listed with "Loaded Driver In safe mode, use Device Manager to replace or roll back potentially problematic drivers, as described in the next section, "How to Roll Back Drivers.

Install the app. Contact us. Close Menu. JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding. You are using an out of date browser. It may not display this or other websites correctly. There is an error logged with raid0 controller but I am not booting from and the storage is just fine and accessible from safe mode. Pasting screenshots here You did not give any info regarding whether you saw any changes in your system reliability.

Did anything help? On the first screen, it has the Diagnostic option. Does your system boot into normal mode if that is checked? You have a lot of stuff on your system, so many possibilities for driver problems. Sorry for being unclear. Those screens show how I already tried it before I posted to this forum.

It did not help. I will try diagnostic. My bootlog show up normally. But I did have to restart twice since the first time I did not hit the Apply button the first time.. If you can't boot into your normal Windows install with the Diagnostic option checked, then a basic problem is probably causing the problem.

You might try running the memory diagnostic. Diagnostic startup didn't help. Why would memory be fine in safe mode but not in normal mode? Kapetan said:. Click to expand Progress made.

I didn't have time to do things one by one, so I am not sure exactly which bit happened, but: I uninstalled few additional bits of software I was reluctant to uninstall initially - Bitdefender Total Security and ASUS motherboard software. I shut the computer down and completely powered it off. I removed one of two memory modules, to check if memory module or controller is causing the issue.

The computer restarted in normal mode still most services and drivers disabled as per previous runs.